Direct ducting to your PLS 4.60 provides protection for operators, reduces product contamination and safeguards sensitive laser optics. Powerful source capture air scrubbers remove pollutants before they become airborne.

The PLS 4.60 is ducted to the RSU 20 CCHR Air Scrubber.

Filter Change Schedule: Electrocorp recommends filters be changed after 8 months of operation or sooner if required. At a minimum, a replacement set of filters should be ordered for standby after 8 months.

Duct Directly to Equipment to Capture Chemicals and Partcles

Laser engravers, large format printers and other equipment may be ducted directley to the RSU 20 CCHR.

Contaminated air is ducted from the engraver or or other equipment directley to the top of the unit. Clean air is ejected 360 deg around the circumference of the unit.

The RSU 20 CCHR delivers up to 400 CFM (Cubic Feet per Minute).

The variable speed control allows you to fine tune motor speed and noise.

Designed for 24 hour operation

Electrocorp air scrubbers have been tested and approved by the Department of Homeland Defense for use by the U.S. Army Corps of Engineers.